Introduction Programming I2C memory devices is a common use case for the Promira™ Serial Platform with I2C Active Level 1-2 Applications. There are several ways to do this with the Promira™ Serial Platform, including using Control Center Serial, Flash Center, or the Promira API. This article focuses on how to how to take the information from an EEPROM datasheet and execute the commands in Control Center Serial Software Command Line mode by using the batch commands and example file. Although the following describes the Atmel I2C EEPROM AT24C02 found on the, similar steps can be used for other devices. Overview In this article the Promira platform writes and reads mutiple bytes from AT24C02. Here the Promira platform is the I2C master and the AT24C02 in the I2C/SPI Activity Board is the I2C slave. The Promira platform is connected to the AT24C02 in the I2C/SPI Activity Board through the 34-10 I2C/SPI cable. The Promira platform supplies 3.3V I2C signals and 5V VDD signal to the I2C/SPI Activity Board. For additional information take a look at and the AT24C02 Detailed In this article, the AT24C02 SCL (Serial Clock Input) and SDA (Serial Data) signals are connected to the Promira platform SCL and SDA signals accordingly. The AT24C02 A0 - A2 (Address Input), WP (Write Protect) and GND (Ground) signals are connected to ground. The AT24C02 VCC (Power Supply) signal is connected 3.3V. Figure 1: AT24C02 Pinouts The AT24C02 I2C EEPROM on the activity board has a hardware configurable I2C target address. The default I2C target address is 1010000b, which is 0x50. This article uses the default I2C target address 0x50. For additional information take a look at. The AT24C02 on the I2C/SPI activity board receives the I2C pulls-ups and power from the Promira platform. In order to supply the I2C pull-ups and target power to the Activity board, the Promira platform and Control Center Serial are configured with the batch command 'configure' to I2C/SPI mode (i2c='1' spi='1' gpio='0'), I2C pull-ups enabled (pullups='1'), and target power enabled (tpower='1'). For additional information take a look at the. The AT24C02 write operation used here is Page Write. The Page Write operation to the AT24C02 requires 7 bit device address, one byte memory address, and two or more bytes of memory data. Performing a memory write operation with the Promira platform requires a single command from the adapter and Control Center Serial. In this case, Control Center Serial batch mode example 'i2c-eeprom-write' is used in order to perform 256 'i2c_write' commands of data 0x00 - 0xFF to memory addresses 0x00 to 0xFF with I2C device address 0x50. For example, take a look at the first and last i2c_write commands. 00 00 FF FF The first command includes the device address (addr='0x50'), number of data bytes (count='2'), data format (radix='16'), memory address (0x00), and memory data (0x00). While the last 'i2c_write' command includes the I2C device address (addr='0x50'), number of data bytes (count='2'), data format (radix='16'), memory address (0xFF), and memory data (0xFF). Figure 2: AT240C Page Write The AT240C read operation used here is the Sequential Read. The AT240C Sequential Read operation first performs I2C write with 7 bit device address, one byte memory address and no stop. Then the AT240C Sequential Read operation performs I2C read with 7 bit device address, two or more bytes of memory data, and stop.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |